Mermade 24" x 45" Centre Bottom Outlet, Complete

The Mer-Made 30" × 36" Center Bottom Outlet — Cover Only (cataloged under Part # 775-COVER / VFC-3036-CBO) is the tailored replacement synthetic fabric filter jacket envelope designed to re-cover existing bare leaf cores in commercial vacuum DE vaults, institutional natatoriums, water parks, and municipal surge-tank filtration arrays.

This model is engineered for vertical-aspect commercial frames measuring 30" wide along the horizontal base by 36" high vertically, with a pre-cut, reinforced cutout collar centered along the bottom 30" horizontal seam. It supplies only the tailored synthetic filtration cloth, centered bottom discharge opening, top closure system, and paired replacement compression sealing gaskets. It is specified when the internal polypropylene drainage grid core and rigid PVC/CPVC border framing remain structurally sound, but the existing fabric has blinded from mineral scale, calcified DE, or body oils, or has suffered physical tears from extended backwash cycles.

Technical Specifications & Scope of Delivery

Material Properties & Chemical Tolerances

• Chlorine & Saline Resistance: Virgin woven polypropylene fibers resist degradation, rot, and hydrolysis under continuous exposure to elevated free chlorine levels, shock hyperchlorination treatments, and saline electrolytic pool water (2,500 to 5,000+ ppm NaCl).

• Acid Wash Survivability: Withstands routine seasonal chemical descaling baths in dilute muriatic (hydrochloric) or citric acid solutions to dissolve calcified DE crust, calcium carbonate, and iron scale without deteriorating seam threads or collar reinforcement stitching.

• Pre-Coat Retention & Release: The balanced monofilament weave structure retains standard DE powder and perlite grades without bleed-through during initial pump startup, while facilitating clean cake release during backwashing or manual hose-down.

Physical Dimensions & Weight Estimates

• Individual Cover Net Weight: Approximately 0.85 to 1.15 lbs (0.39 to 0.52 kg).

• Single Boxed Cover Shipping Weight: Approximately 1.85 to 2.80 lbs (0.84 to 1.27 kg) in a compact corrugated carton.

• Master Carton / Multi-Pack (6 to 12 Covers): Approximately 7.5 to 14.0 lbs (3.4 to 6.4 kg).

• Full Bank Overhaul Pack (20 to 30 Covers): Approximately 20.0 to 32.0 lbs (9.1 to 14.5 kg).

Field Re-Covering & Tensioning Steps

1. Strip Old Jacket & Inspect Frame: Remove the spent leaf from the pit, open the top Velcro closure, and peel the spent cover off the frame. Discard the compressed felt collar. Pressure-wash the bare polypropylene drainage grid and inspect the outer PVC borders for rough weld beads, flash, or cracks that could snag or cut the new fabric during sleeving.

2. Sleeve the Frame: Slide the replacement envelope down over the 36" height of the frame along the 30" width, guiding the reinforced center opening over the protruding center-bottom discharge spud.

3. Seat the Spud Collar: Stretch the reinforced collar cutout snugly around the base of the center hub until seated flush against the molded locating shoulder without bunching or twisting.

4. Tension & Seal: Pull the fabric upward evenly from both sides across the 30" × 36" face to eliminate wrinkles or bagging (loose fabric allows DE cakes to bridge, sag, and slough off under vacuum). Firmly press the Velcro closure flap closed across the 30" top rail to lock in uniform tension.

5. Mount Gasket: Slide a fresh high-density felt compression collar onto the center-bottom outlet spud against the locating shoulder before lowering the re-covered leaf back into the floor manifold receiver socket.