NORDESCO Wall Mount Bench 10ft - Grey

The Nordesco 10-Foot Wall-Mount Bench (Grey) is the maximum commercial single-run cantilevered seating installation offered in Nordesco’s wall-mount series. Engineered for massive-capacity aquatic and athletic venues—such as major municipal natatoriums, university athletic complexes, and public recreation changing concourses—it provides expansive linear seating without touching the deck.

Functional Overview & Materials

Designed to optimize wall utilization across extensive perimeter spans while leaving floor planes completely clear for operations:

• High-Density Polypropylene Slat Assembly: Fabricated from UV-stabilized, non-porous thermoplastic slats in neutral grey. Highly resistant to chloramine-laden atmospheres, aggressive chemical washes, body oils, and continuous moisture without cracking, warping, splintering, or supporting mildew.

• Rapid Drainage & Airflow: Longitudinal drainage slots allow pool runoff, washdown water, and perspiration to drain immediately, accelerating air drying and maintaining slip resistance for barefoot patrons.

• Reinforced Multi-Bracket Cantilever Frame: Supported by six to seven heavy-gauge, electropolished 304 or 316 stainless steel cantilever brackets to provide structural rigidity, eliminate center deflection across the 120-inch span, and transfer high dynamic loads safely into the building structure.

• Unobstructed Floor Maintenance: Wall-mounted elevation leaves the floor 100% open, allowing commercial floor machines, wide squeegees, and pressure washers to operate wall-to-wall without obstacles or hard-to-clean floor penetrations.

Technical Specifications

• Nominal Length: 120 inches (10 feet / approx. 304.8 cm).

• Bench Depth / Seat Width: Approximately 12 to 14 inches (approx. 30.5 to 35.5 cm) projection from the finished wall face.

• Load Rating: Rated for 1,500 to 1,750 pounds (680 to 794 kg) uniformly distributed commercial working load when anchored according to engineering specs into poured structural concrete, fully grouted CMU masonry, or heavy continuous steel in-wall blocking.

• Bracket Count: 6 to 7 heavy-duty stainless steel cantilever brackets with pre-drilled mounting flanges sized for 3/8" or 1/2" commercial structural anchors or through-bolts.