NORDESCO Wall Mount Bench 11ft - Grey

The Nordesco 11-Foot Wall-Mount Bench (Grey) is a custom-length, high-capacity commercial cantilevered seating installation. It is built to order for oversized aquatic and athletic facilities—such as collegiate fieldhouse natatoriums, stadium team locker rooms, and long wet-corridor staging bays—where a continuous, wall-anchored run is required without ground contact.

Functional Overview & Materials

Designed to bridge extended wall spans while keeping the floor completely open for sanitation and transit:

• High-Density Polymer Slat Platform: Composed of heavy-duty, UV-stabilized virgin polypropylene slats in neutral grey. The solid, non-porous structure does not absorb water, sweat, body oils, or chloramines, completely eliminating rust, splinters, rot, and fungal accumulation.

• Rapid Drainage & Airflow: Longitudinal spacing between slats allows shower spray and pool splash-out to drain instantly to the floor drainage grid, accelerating evaporation and providing a non-slip surface for barefoot or wet-suited patrons.

• Multi-Point Cantilever Substructure: Supported by seven heavy-gauge, electropolished 304 or 316 stainless steel cantilever brackets to provide structural rigidity, eliminate center-span deflection across the 132-inch span, and distribute dynamic occupant shifts safely into the wall structure.

• Unobstructed Deck Sanitation: The off-floor cantilever profile permits floor scrubbers, wide squeegees, and pressure washers to clean wall-to-wall without navigating around floor legs or creating dirt and moisture traps.

Technical Specifications

• Nominal Length: 132 inches (11 feet / approx. 335.3 cm).

• Bench Depth / Seat Width: Approximately 12 to 14 inches (approx. 30.5 to 35.5 cm) projection from the finished wall surface.

• Load Rating: Rated for 1,650 to 1,900 pounds (748 to 862 kg) uniformly distributed commercial working load when anchored according to engineering specs into poured structural concrete, fully grouted CMU masonry, or continuous structural in-wall blocking.

• Bracket Count: 7 heavy-duty stainless steel cantilever brackets with pre-drilled flange holes sized for 3/8" or 1/2" commercial structural anchors or through-bolts.