NORDESCO Wall Mount Bench 12ft - Grey

The Nordesco 12-Foot Wall-Mount Bench (Grey) is the maximum extended-run cantilevered commercial bench configuration in the Nordesco aquatic seating series. Engineered for massive linear wall expanses—such as Olympic and varsity fieldhouse locker rooms, large municipal pool staging perimeters, and high-occupancy aquatic therapy staging corridors—it provides maximum seated capacity while preserving a completely open floor plane.

Functional Overview & Materials

Designed to bridge 144 inches of architectural wall surface without introducing floor-level obstructions:

• High-Density Polymer Slat Assembly: Constructed from UV-stabilized, high-impact virgin polypropylene slats in neutral grey. The solid, non-porous structure is impervious to chloramine vapor, chlorinated splash-out, cleaning detergents, and body oils, eliminating risks of rust, delamination, splintering, or fungal accumulation.

• Rapid Drainage & Airflow: Longitudinal drainage slots allow pool runoff, washdown water, and moisture to drain immediately, accelerating evaporation and maintaining slip-resistant seating for barefoot or wet-suited patrons.

• Heavy Multi-Point Cantilever Substructure: Supported by seven to eight heavy-gauge, electropolished 304 or 316 stainless steel cantilever brackets to provide structural rigidity, eliminate center-span deflection across the 144-inch run, and distribute dynamic occupant shifts safely into the wall structure.

• Unobstructed Floor Sanitation: Elevating the entire assembly off the deck allows automated scrubbers, wide floor squeegees, and pressure washers to clean wall-to-wall without navigating around pedestals or creating moisture traps.

Technical Specifications

• Nominal Length: 144 inches (12 feet / approx. 365.8 cm).

• Bench Depth / Seat Width: Approximately 12 to 14 inches (approx. 30.5 to 35.5 cm) projection from the finished wall surface.

• Load Rating: Rated for 1,800 to 2,100 pounds (816 to 952 kg) uniformly distributed commercial working load when anchored according to engineering specs into poured structural concrete, fully grouted CMU masonry, or continuous structural in-wall blocking.

• Bracket Count: 7 to 8 heavy-duty stainless steel cantilever brackets with pre-drilled flange holes sized for 3/8" or 1/2" commercial structural anchors or through-bolts.